RJ80

I just bought a set of Bosch spark plug wires (they are made with Beru ends) and set to replacing the Berus on my car since one had worn through its insulation. I got the main four wires replaced from the cap to the plugs, but I don't see how to remove the wire from the coil. There's a plastic cover over the assembly and I can't figure out how to remove it.

Thanks for any help!

RJ80

No one here has done this before? Is there a better area of this site or a different site altogether that may get my question answered? I'm fairly new to the 944. Thanks!

Dimi 944

The plastic cover over the coil is held in closed position by a plastic rivet. Just pop it open with a screw driver. That is all.

RJ80

Thanks for the response. I was able to pry it apart without trouble, but it's going to take some wrangling to remove it and get to the wire, looks like. Hopefully I don't have to remove the headlight motor.

leftarmer

@RJ80 were you able to figure out how to get to coil wire and replace it?

ElRicardo

Did you get the wire off? I think I saw your same question on a different forum, so if you didn’t get a good answer PM and I can give you better instructions how to get that cover off.