Frenzy 18 (2014) for sale/swap thread.
#61
Rennlist Member
I have some parts from various older twinscrew setups if anyone is interested in an Autorotor MX-417 with driver snout, or any of the various other bits and bobs from the ~2007 setups. Can look for specific items if anyone is interested. I need to make some room for the new assemblies.
I will also bring several sets of the rear drop links.
See everyone Friday.
I will also bring several sets of the rear drop links.
See everyone Friday.
#63
Rennlist Member
Anyone have a RMB that will fit my 85, they want to sell?
#65
Rennlist Member
I could be wrong, but I don't think it does. Thanks Bilal.
Could someone clear this up for me? My understanding is that the 87+ just bolt on but can they be used on the earlier models if welded on? I can't seem to find an answer by searching RL.
Could someone clear this up for me? My understanding is that the 87+ just bolt on but can they be used on the earlier models if welded on? I can't seem to find an answer by searching RL.
Last edited by WyattsRide; 09-23-2014 at 03:23 PM.
#67
Rennlist Member
If anyone has a driver's side drip edge end (preferably black)...
It's the little end cap with the foot that screws down with a Phillips head.
I tried to bend the driver's side drip edge on my GT before I realized that it was cast metal and wouldn't take to bending
It's the little end cap with the foot that screws down with a Phillips head.
I tried to bend the driver's side drip edge on my GT before I realized that it was cast metal and wouldn't take to bending
#69
Rennlist Member
#72
Race Car
c'mon
All else aside, the bumper cover is the thing- 87+ exits straight out the back, S3 exits under the corner~~
#73
Bringing a set of brown carpet (4 pcs) for an OB, a couple air intake tubes that are NOT for an 85-86, a few replacement power seat bushings, and some misc smaller stuff
#75
Race Car