Injector spacing..
#1
Thread Starter
Injector spacing..
going to cut and weld my Billet rail project soon. wanted to double check what the actual center to center between two injectors is. i got 114mm.
anyone have a rail off they could measure for me?
anyone have a rail off they could measure for me?
#4
Man of many SIGs
Rennlist Member
Rennlist Member
How the heck did you get 114mm ? Thats a big difference. Double check my math but that's what I measured on mine and thats what I machined my rails to fit.
#5
Thread Starter
ya its 121. i was going in-between in injector boss's and was doing it all by holding it down with my fingers. but today i cut the rails to length and used tape to hold on the injector boss with the injectors... trial fit. works good.
BUT.... my damn TIG welder keeps blowing the breaker (dryer outlet) when i try to get the amps hot enough to weld the damn rail..... UGH.... i hate not having my own shop with a good welding rated outlet.
now i have to find a welding shop.... GURRRR..... And i went to school for welding and i have to pay some else to do it... Sigh...
BUT.... my damn TIG welder keeps blowing the breaker (dryer outlet) when i try to get the amps hot enough to weld the damn rail..... UGH.... i hate not having my own shop with a good welding rated outlet.
now i have to find a welding shop.... GURRRR..... And i went to school for welding and i have to pay some else to do it... Sigh...
#7
Former Vendor
Trending Topics
#8
Man of many SIGs
Rennlist Member
Rennlist Member
What is a TS kit?