jimlam56

I'm going to delete my rear window wiper assembly today.
It looks like you have to cut off the motor support with a dremel or something.
Am I correct?
Thanks,
Jim

LexVan

Always measure twice. Cut once.

mj951

I don't recall having to cut anything and very much doubt you should have to. Has been to long to recall the exact process but i'm sure it's a bolted connection. Did you remove the wiper arm and remove the large nut on the shaft that comes through the glass?

jimlam56

I'll look again but it seems that there is 2 rods about 1/8 inch in diameter that are welded to the hatch frame and support the motor assembly.

fejjj

No cutting required.

s14kev

Those rods are not welded. Just embedded in rubber.

jimlam56

OK, thanks guys!
Anybody want the assembly?

fasteddie313

could use the wiper arm, and that little rubber seal that goes on the shaft under it... mine is whomped out where it goes on the spline axle..

price for arm and seal shipped?

price for whole shot shipped?

plyhammer

Just pull and it will pop right out. You may have to cut a couple of the wires but that is all.

jimlam56

No charge, you just pay freight.

For what it's worth, the whole assembly weighs in at a little over 4 pounds...

fasteddie313

deal... you can pm me paypal info or email me at ed.leclair@yahoo.com

kens_74911s

I have a good Wiper delete plug if you need one.

$25 shipped, paypal is; porscheken@nc.rr.com

Ken in NC

jimlam56

Thanks, I got one already.

jimlam56

So did you ever get the wiper assembly I sent you ?
Never heard back from you....